DC Audio 7.5K Monoblock 7500W RMS Amplifier

The 7.5K competition series amplifier is a 7,500 watt mono block. It is capable of running up to 18 volts for up to 9,200 watts. It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped. It comes with a bass knob and a clipping indicator. For power inputs it will accept dual 0 AWG for power and dual 0 AWG for ground.

• Features: 1-ohm stable, Variable low pass filter, Variable subsonic filter, Variable bass boost, Wired remote control, and Dual 0 AWG power and ground inputs (both must be used).
• Specifications: Output Power: 2,000W x 1 at 4-Ohm 14.4V | 4,400W x 1 at 2-Ohm 14.4V | 7,500W x 1 at 1-Ohm 14.4V | 8,600W x 1 at 1-Ohm 16V | 9,200W x 1 at 1-Ohm 18V. Input Sensitivity: 6V - 0.2V, Low Pass Filter (at 24dB Slope): Switchable Variable 35 - 250Hz, Subsonic Filter (at 24dB Slope): Switchable Variable 10 - 50 Hz.
• Bass Boost: 0-9dB Variablem Frequency Response: 15-270Hz, Signal-to-Noise Ratio: 100dB, Damping Factor: <150, Efficiency at 4-Ohm: Over 90%, THD at 4-Ohms: Less than 0.1%, Fuse Rating: 750 Amps, Lined Fuse Rating: 1,500 Amps, Indictor: Power, Protection, Speaker and Power Terminal: Mold Type, Heatsink Length: 32.28".
• Install Recommendations: 1 upgraded battery under the hood, 3 extra 800ci battery in the rear, Minimum of two 0 awg ran from the front battery to the rear battery, Both 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 4 runs into the amp, 2 Upgraded aftermarket alternators, and Dash mounted voltage meter.